Ecoray 72DX (new)

NEW FEATURES:

  • NEW!  User replaceable LED board, just use a screwdriver
  • NEW! 72 Watts, over 70% larger light spread vs Ecoray 60D.
  • NEW! DUAL DIMMERS –one dimmer for Blue LED’s, one dimmer for White LED’s.
  • NEW! All Clear lenses
  • NEW! Independent LED circuit design. If a single LED fails, it won’t affect any other LED’s.
  • NEW! Easy Access to LED’s through removable glass cover. 
  • NEW! Bridgelux LED chips.
  • Overall color temperature about 25,000 K
  • Corrosion-resistant High Quality All Aluminum Housing
  • Deep Light Penetration
  • PAR at 24” from center: 400+

Features and Benefits:

Brighter than Metal Halide HQI
400+ PAR value at 24″ from center is approximately 60% brigther than a 250W Metal Halide HQI. Specially designed lenses provide the best combination of high PAR and light spread. For a 24” deep tank, we recommend one Ecoray 72DX  for approximately 24″ x 17” area to provide 150+ PAR at 24” around the perimeter of the 24” x 17” area, increasing to 400+ PAR toward the center. For larger coverage, place it higher above the water level. Deeper tanks will automatically get larger coverage. 150+ PAR is generally considered to be the minimum lighting requirement for LPS corals while clams and SPS corals generally require 300+ PAR. Do not be confused with many low PAR LED units in the market claiming large coverage area for similar or higher wattage, these units generally produce only 40 to 100 PAR at 24” from center (one tenth to one fourth the PAR of Ecoray 72DX). These low PAR LED units do not provide adequate lighting intensity and they are not suitable for reef aquariums with LPS and SPS corals.

200+ PAR at 24” from center with only Blue LEDs on
Turn on the Blue LEDs only and watch the intense colors of your corals.

Click here to see PAR Demonstration

Up to 110 lumens per watt
Latest generation High Power 1 Watt LED produces up to 100 lumens per watt, more than 50% higher lumens output compared to older generation 1 Watt LED.  The 72 1 watt LEDs combined are brighter and more efficient than 24 3 watts LEDs, with much lower heat.

Check out this article by Dr. Sanjay Joshi comparing light intensity and distribution of Ecoray 112D against other LED manufacturers

Cooler operation
With 1 Watt LEDs, an aluminum PCB, a thick aluminum base plate that serves as heat sink and super quiet cooling fan,  the Ecoray 72DX produces an LED junction temperature of only 56 °C (133 °F), far lower than the 88 °C  (190 °F) allowable maximum.

Modular design fits most reef tank sizes
Fits most reef tank sizes.  For full coverage, place Ecoray 72DXs  about 5 inches apart.  Get larger spread and wider separation by placing Ecoray 72DX higher above the water level.  Install either the short or the long side facing the front. For example:
-a tank 48″ wide by 20” front to back width by 24″ deep, would use 2 Ecoray 72DXs with the long side facing the front.
-a tank 72″ wide by 26” front to back width by 30″ deep, would use 4 Ecoray 72DXs with the short side facing the front.

Save 50% energy
Use at least 50% less energy than 250 W Metal Halide lights, while getting much higher intensity.

Eliminate Metal Halide bulb replacement costs
Metal Halide requires bulb replacement every 6 to 9 months at a cost of $60 to $80 per bulb. LEDs have life expectancy of up to 50,000 hours.

Eliminate cooling costs
Due to the intense heat generated by Metal Halide lighting, a separate cooling system is usually required that consumes additional energy and expense.

All Aluminum Housing
The high quality, corrosion-resistant, light weight, all aluminum housing is designed to last a long time over your reef aquarium. Most competitors’ models are made of painted steel which will corrode in 12 months or less.

Completely Sealed Electronics
PCB board, LEDs and all electronics are completely sealed to prevent moisture and air from entering the sealed area. Drivers are located outside the sealed area to allow for easy replacement, if necessary.

Compact, Light Weight and Simple
No separate, heavy ballast boxes or an on/off switch. Simply plug  the Ecoray 72DX into your timer, and then into an electrical outlet.

Highly competitve pricing

 

Specifications:
36 White High Power 1 Watt LED, Color Temperature 12,000K – 16,000K
36 Royal Blue High Power 1 Watt LED, Wave Length 450-460 nms
Overall Color Temperature 20,000K – 25,000K
76 W, 110 V – 240 V, Dual 12 ft electrical cords
Built-in fan
All Aluminum Housing 19.2” x 11.2” x 2.6”, 12 lbs
Supporting L Brackets (not shown in photo) and hanging wire included

Exclusive Worldwide Distributor:
Underwater World, Los Angeles, CA.
Email: sales@uwwe.com, Ph: 310-670-1502

Dealer Inquiries Welcome.
We do not sell directly to the general public, please check availability with your local or online retailers or contact us for a dealer near you.

Warning:  Ecoray sold out of China are not genuine Ecoray.  They are inferior in performance and carry no warranty.  Buy only through Underwater World and its dealers for genuine Ecoray.

Ecoray is trademark of Naxandra Corporation.
Copyright 2010 – 2013 Naxandra Corporation. All rights reserved.